Starting generation of Calibration File 
FS version = 0009.0011.0019 
time_zero = 1015200 
Found #134 errors of type = ERROR st   -7 Antenna off-source! 
Found #68 errors of type = ERROR fl   -1 Previous source in this schedule not reached before new source was commanded 
Found #50 errors of type = ERROR qo -301 WARNING: ONSOURCE status is SLEWING! 
Found #49 errors of type = ERROR an -103 Pointing computer tracking errors are too large. 
Found #6 errors of type = ERROR st   -4 Interface not set to remote. 
Found #6 errors of type = ERROR st   -6 Antenna control restored. 
Found #5 errors of type = ERROR 5k  302 There have not been two scan_name ... commands since the schedule started  use scan_check force to force check 
Found #5 errors of type = ERROR st -994 No new wx data since last report 
Found #1 errors of type = ERROR m5 -900 : not doing anything 
Found #1 errors of type = ERROR bo -262 Cannot change schedules while recording  use disk_record off to stop. 
Found #1 errors of type = ERROR qk -211 Tsys value for device ic overflowed or was less than zero. 
Found #1 errors of type = ERROR m5 -906 MARK5 return code 6: inconsistent or conflicting request 
Found these BBCs:   
NBBC: 0
Found these SK parameters: get get get
RX1 min= 100000 max= 2018.011.18:30:04.17
RX2 min= 100000 max= -1
RX3 min= 100000 max= -1
Plotting 0 Tsys channels:   
Tsys values are: -1 1 2 etc
NTSYS: 0