Starting generation of Calibration File FS version = 0009.0011.0019 time_zero = 2833200 Found #41 errors of type = ERROR st -7 Antenna off-source! Found #5 errors of type = ERROR st -4 Interface not set to remote. Found #5 errors of type = ERROR st -6 Antenna control restored. Found #1 errors of type = ERROR qk -211 Tsys value for device du overflowed or was less than zero. Found #1 errors of type = ERROR mc -2 Interface b2 responded but did not ACKnowledge. Found #1 errors of type = ERROR st -823 sxcheck sup is 229.546. (should be 230.000 to 315.000) Found #1 errors of type = ERROR mc -2 Interface ba responded but did not ACKnowledge. Found #1 errors of type = ERROR st -823 sxcheck sup is 327.738. (should be 230.000 to 315.000) Found #1 errors of type = ERROR st -823 sxcheck sup is 324.807. (should be 230.000 to 315.000) Found #1 errors of type = ERROR qo -301 WARNING: ONSOURCE status is SLEWING! Found #1 errors of type = ERROR mc -2 Interface bd responded but did not ACKnowledge. Found #1 errors of type = ERROR ch -212 bd LO unlocked. Found #1 errors of type = ERROR an -103 Pointing computer tracking errors are too large. Found these BBCs: bbc01 bbc05 bbc09 NBBC: 3 Found these SX parameters: slo xlo sup RX1 min= 3.87 max= 3.89 RX2 min= 4.75 max= 4.77 RX3 min= 252.02 max= 267.16 Plotting 3 Tsys channels: 01 05 09 Tsys values are: -1 1 2 etc NTSYS: 3 in match_chan ft1= r4827kk.log.tsy1.ntup nt1= 8 st1= 1u tt= 1 set scale tsys1 [2] min max 58.5 211.4 set scale tsys2 [2] min max set scale tsys3 [2] min max set scale tsys4 [2] min max Tsys scale ymin 52 ymax 214.4 in match_chan ft1= r4827kk.log.tsy1.ntup nt1= 20 st1= 5u tt= 1 set scale tsys1 [2] min max 58.5 211.4 set scale tsys2 [2] min max set scale tsys3 [2] min max set scale tsys4 [2] min max Tsys scale ymin 33.1 ymax 181.6 in match_chan ft1= r4827kk.log.tsy1.ntup nt1= 13 st1= 9u tt= 1 set scale tsys1 [2] min max 58.5 211.4 set scale tsys2 [2] min max set scale tsys3 [2] min max set scale tsys4 [2] min max Tsys scale ymin 23.5 ymax 80.8