Starting generation of Calibration File 
FS version = 0009.0012.0011 
time_zero = 3427200 
Found #16 errors of type = ERROR st -999 Reply time-out 
Found #16 errors of type = ERROR st   -5 Antenna communication error  see above errors. 
Found #9 errors of type = ERROR st  -50 Antenna NOT fully moveable  see above errors. 
Found #9 errors of type = ERROR st  -72 Elevation (motor) Brake Alarm on. 
Found #7 errors of type = ERROR st  -66 Azimuth Master Brake Alarm on. 
Found #7 errors of type = ERROR st  -53 Antenna control timed-out. 
Found #7 errors of type = ERROR st  -47 Antenna Control Timeout should be enabled but is disabled. 
Found #7 errors of type = ERROR st  -77 Elevation Slave Brake Alarm on. 
Found #7 errors of type = ERROR st  -76 Azimuth Slave Brake Alarm on. 
Found #6 errors of type = ERROR st  -24 Antenna not ready  verify condition  start with antenna operate 
Found #6 errors of type = ERROR qo -301 WARNING: ONSOURCE status is SLEWING! 
Found #5 errors of type = ERROR st -998 read ReadGroup 
Found #4 errors of type = ERROR st -998 write timeout reset 
Found #4 errors of type = ERROR an -103 Pointing computer tracking errors are too large. 
Found #3 errors of type = ERROR st  -93 Wait for power-off and drives to trip timed-out. 
Found #3 errors of type = ERROR st -998 write regs 
Found #2 errors of type = ERROR st   26 ACU-FS Time difference now nominal. 
Found #2 errors of type = ERROR sp   -4 Unrecognized name (not a function or procedure). 
Found #2 errors of type = ERROR st -998 write ReadGroup 
Found #2 errors of type = ERROR st -998 reading epoch 
Found #1 errors of type = ERROR st    6 ACU-FS time difference -344 ms  exceeds 250 ms. 
Found #1 errors of type = ERROR 2b -304 IF 0 RMS too high  rdbca 
Found #1 errors of type = ERROR st    6 ACU-FS time difference -328 ms  exceeds 250 ms. 
Found #1 errors of type = ERROR st    6 ACU-FS time difference -321 ms  exceeds 250 ms. 
Found #1 errors of type = ERROR m6 -104 mk6ca: time-out  connection closed  will reopen on next attempt 
Found these BBCs:   
NBBC: 0
Found these  parameters:   
RX1 min= 100000 max= -1
RX2 min= 100000 max= -1
RX3 min= 100000 max= -1
Plotting 0 Tsys channels:   
NTSYS: 0